• Spin Trimming Deflashing Machine for O rings Finishing Process
  • Spin Trimming Deflashing Machine for O rings Finishing Process
  • Spin Trimming Deflashing Machine for O rings Finishing Process
  • Spin Trimming Deflashing Machine for O rings Finishing Process
  • Spin Trimming Deflashing Machine for O rings Finishing Process

Spin Trimming Deflashing Machine for O rings Finishing Process

Model No.︰

-

Brand Name︰

-

Country of Origin︰

China

Unit Price︰

-

Minimum Order︰

1 pc

Share on:

Product Description

O rings Spin Trim Deflashing Machine

Introduction

The NANJING PEGE’s Spin Trim Rubber Deflashing Machine is a simple and cost-effective method of deflashing small rubber parts.

It can be used as a single process operation or as a cost reducing first stage before cryogenic deflashing for excessive flash.

This machine using centrifugal force principle, the inner cylinder with automatic control of high-speed rotating disk driven rotating rubber products constantly collide, making edges and rubber products separated from each other, to achieve the function of removing burrs.

Applies to all rubber seals and other rubber rings molding burrs after the demolition work.

Advantages of Spin trim deflashing rubber machine

An affordable system of mechanically deflashing rubber parts that provides quick pay back & improved finish quality

    A very compact and quick solution for the deflashing of rubber parts

    A simple method of operation and exceptionally easy to maintain

    A system that eliminates safety risk and time taken with manual trimming

 

When should I use the Spin Trim?

The SpinTrim is ideal for the high quality deflashing of small to medium size rubber parts that do not have excessive flashing or for more excessively flashed product when the application does not require a pristine finish.

It separates the sprue and the unwanted flash surrounding the product in a short period of time (usually about a minute). It offers considerable cost, time and quality and safety advantages over hand-cutting, grinding, chemical or tumbling methods of deflashing.

However, it is also a cost-effective first stage process for the deflashing of more complex parts or those that have excessive flash prior to using a Pege ‘Frozen Shot’ cryogenic deflashing machine. The benefit of having a two-stage process is that it reduces the time taken during cryogenic deflashing including the amount of nitrogen used - reducing operational costs. It also means that a higher quality part is produced as the cryogenic and media blasting process can concentrate on polishing and fine trimming the parts.

Take-off waste separator now also available

The separator has 14 perforated sheets of differing hole sizes so you can set the separator up for each product. The upper sheet allows the good parts and small flash to fall through. The lower sheet then allows this flash to fall to the bottom, leaving the deflashed parts in the middle of the separator. Boxes at the end collect the deflashed parts and flash. The large flash is manually removed for the upper sheet by hand or vacuum.

This optional extra will save labor time and cost in sorting out the parts and is compact and very efficient and simple to operate.

 

Automatic Rubber Deflasher machine with Spin Trim

Chinese High-Quality Rubber Spin Trim Machine With Separator

Automatic rubber deflasher for O rings and gaskets

Spin trim deflashing rubber machine

Automatic Spin trim O Ring Rubber Trimming Machine

Automatic Spin Trim Rubber deflashing machine for O ring

Automatic rubber washer deflashing machine

Spin trim Rubber parts deflashing/edge trimming machine

Spin trim Rubber Deflashing Machine Rubber Separator

Silicone rubber ring spin trim deflashing machine

NBR, ACM, NR EPDM orings automatic deflashing machine



Payment Terms︰ T/T/L/C
Lead Time︰ 30Days after the prepayment
Standards Certificate︰ ISO9000:2000

Product Image